Ooh ooh...first one to post....FS--Emerson built Ridgid TS2424 contractor table saw

Mark Rios

Member
Messages
797
Location
Central CA
Ridgid TS2424 Table Saw

I purchased the saw new from HD in the fall of 1998. It has an "Inline Industries Contractor PALS" kit on it (to make adjusting very easy) and I also have a machined and balanced set of pulleys, plus a link belt, that haven't been installed yet. It's been well taken care of and is in great shape. Never had to do any repairs and has never had a problem. It has a factory built in/on mobile base, two wheels on one end and one wheel on a lever on the other end kind of thing. Cast iron table and "webbed" cast iron wings. It's a Ridgid TS2424 but I've moved the rails, for a 31" cut on the right side and 18+" on the left, and replaced the measuring tape on the front rail on both sides. It comes with one (1) ZCI, one (1) factory single blade insert and one (1) factory dado insert.

The motor sticker is completely intact but in the spot for the HP, nothing is listed. To do your own HP calcs, the sticker lists the amp draw at 13 amps@120V. It can run on 120V OR 240V. It now runs on 120V. The sticker lists two speeds 2850 rpm and 3450 rpm. My calcs put it at 1.5HP

$250

This saw is in Modesto CA.

Shipping is impractical. :D

PM if you want it.

Pic of the saw;

http://familywoodworking.org/public_html/forums/attachment.php?attachmentid=263&d=1162681484

http://familywoodworking.org/public_html/forums/attachment.php?attachmentid=262&d=1162681474

http://familywoodworking.org/public_html/forums/attachment.php?attachmentid=264&d=1162681493
 
Top