- Messages
- 11,430
OK since I am planing a new shop lay outI figured I'd run this by you guys for comments.
right now everything is in the small 10x20 space on the right, the dust collector sits next to the table saw with 2 hoses hooked up to it one to the Planer and one to the table saw. The large workbench is non existant and the miter saw is sitting on a small bench. This layout will allow me to do hoock all of the machines up except the Band saw to the DC. I will build a proper Miter saw bench with a bunch of drawers for storage and a proper work bench. I can't move everything into the larger 2 car garage but I do have room for a few machines. And larry No I am not moving the lathe down the street as you suggested while you were here.
Comment and suggestions are welcome.
right now everything is in the small 10x20 space on the right, the dust collector sits next to the table saw with 2 hoses hooked up to it one to the Planer and one to the table saw. The large workbench is non existant and the miter saw is sitting on a small bench. This layout will allow me to do hoock all of the machines up except the Band saw to the DC. I will build a proper Miter saw bench with a bunch of drawers for storage and a proper work bench. I can't move everything into the larger 2 car garage but I do have room for a few machines. And larry No I am not moving the lathe down the street as you suggested while you were here.
Comment and suggestions are welcome.
Attachments
Last edited: