Pete Simmons
Member
- Messages
- 546
- Location
- Melbourne, FL
Here is a pen box that I made for a very special Pen Presentation.
Laser inlayed with the real small parts done in the fashion of a wood rubber stamp.
I think this picture is actually bigger than the real thing.
Used dyed maple for the red, green and blue. Yellowheart for the crosses and stars.
For the small stuff here is how:
1.You etch the area out of the box.
2. Make a wooden rubber stamp (mirror image of the etched area)
3. Glue and force wood (rubber stamp) into etched area
4. Sand smooth
Laser inlayed with the real small parts done in the fashion of a wood rubber stamp.
I think this picture is actually bigger than the real thing.
Used dyed maple for the red, green and blue. Yellowheart for the crosses and stars.
For the small stuff here is how:
1.You etch the area out of the box.
2. Make a wooden rubber stamp (mirror image of the etched area)
3. Glue and force wood (rubber stamp) into etched area
4. Sand smooth
Attachments
Last edited: