Les Elm
Member
- Messages
- 1,435
- Location
- Red Deer, Alberta, Canada
Polyester Resin casting using Shredded Canadian Currency.
Started with a small mold to see how it was going to turn out.
Mold is 3" X 3" X 1" which is enough to get 3 - 3" X 1" blanks.
Turned out great with no air bubbled or voids!
Next attempt will be with a 5.25" X 6" X 1" slab using a mold I made using a plastic cutting board. Will be able to get 7 - 1" X 5.25" pen blanks.
Les
Started with a small mold to see how it was going to turn out.
Mold is 3" X 3" X 1" which is enough to get 3 - 3" X 1" blanks.
Turned out great with no air bubbled or voids!
Next attempt will be with a 5.25" X 6" X 1" slab using a mold I made using a plastic cutting board. Will be able to get 7 - 1" X 5.25" pen blanks.
Les