Bob Gibson
Member
- Messages
- 11,481
- Location
- Merrimack, New Hampshire
I recently gave away my fancy crosscut sled when I sold the Shopsmith.
I threw this together quickly because I had to cut the lid of the chest I'm making. The lid was teetering a bit so I put this clamp on the help keep it stable when I cut it to length.
It worked just fine but the more I thought about it I wondered if it was a potential safety hazard
Should I take it off or is it Ok to use when cutting long panels.
I threw this together quickly because I had to cut the lid of the chest I'm making. The lid was teetering a bit so I put this clamp on the help keep it stable when I cut it to length.
It worked just fine but the more I thought about it I wondered if it was a potential safety hazard
Should I take it off or is it Ok to use when cutting long panels.