Results 1 to 2 of 2

Thread: LOML is droving me carzy

  1. #1
    Join Date
    Oct 2006
    somewhere east of Queen Creek, AZ - South East of Phoenix

    Unhappy LOML is droving me carzy

    She is my QC department for the church commission and she has been telling me that the chairs are cockeyed. Tonight I asked her to show me what she ment by cockeyed and she proceeded to take out a tape measure and show me where the upoulstered seat on one of the chairs was 1/8 different side from front to back then other side. I messaged the foam a little and put it back in line with the other side and she still said well they wont be doing that when they sit on it... Can't do much about foam...
    Last edited by Don Baer; 06-30-2010 at 03:15 AM.
    "Thereís a lot of work being done today that doesnít have any soul in it. The technique may be the utmost perfection, yet it is lifeless. It doesnít have a soul. I hope my furniture has a soul to it." - Sam Maloof
    The Pessimist complains about the wind; The Optimist expects it to change;The Realist adjusts the sails.~ William Arthur Ward

  2. #2
    Join Date
    Aug 2007
    Reno NV
    Sounds like you got a good QC Department. Wouldn't dare fire her if I were you...
    Programmer - An organism that turns coffee into software.
    If all your friends are exactly like you, What an un-interesting life it must be.
    "A door is what a dog is perpetually on the wrong side of" Ogden Nash

Similar Threads

  1. A pen for LOML DIL
    By Ken Ward in forum Lathe Project Showcase
    Replies: 5
    Last Post: 04-18-2011, 10:33 PM
  2. LOML went to lowes again
    By Alan Bienlein in forum New Tools
    Replies: 6
    Last Post: 04-09-2010, 10:48 AM
  3. LOML did it again! .... Update
    By Alan Bienlein in forum New Tools
    Replies: 11
    Last Post: 10-03-2009, 03:36 AM
  4. Just had the following converstation with LOML
    By Don Baer in forum Off Topic Discussion
    Replies: 27
    Last Post: 08-22-2009, 02:29 PM
  5. Cathie, LOML
    By Royall Clark in forum Off Topic Discussion
    Replies: 53
    Last Post: 05-08-2009, 04:49 PM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts