Dan Mosley
Member
- Messages
- 1,169
- Location
- Palm Springs, Ca
Pictures 1-2 .......Pepperwood Vessel (10 1/2" wide - 8 1/2 tall) out of 24hr soaking now and letting dry inside and hoping it does not crack. I wiped it down well and let it dry for several hours inside and it began to look fairly dry so I put a coat of DO on it and let sit for for a bit and wiped it down. Now sitting and drying......will watch it and see how it goes now...........dang So.Calif heat is kicking my butt on any of my turnings now........
Pictures 3-4 ........Long neck vessel with a small finial - now complete
Picture 5 -Small vessel complete - now it has a finial
Picture 6 .......Natural Edge Small bowl - Sanded to 400 and 2 coats of DO, now sitting and drying.
Questions - I usually use my Ci1 to clean up the bottom nub on the inside of the vessels which is quick and easy to do......anybody else doing it another
way?
I have been using a Mandrel to reverse and part off.......how is everybody else doing it ? (see Picture 7)
Prior to turning any of the natural edge pc's I have been putting CA glue on the bark near the middle to help hold it in place. Then making my
cuts away from the natural edge............anyone else doing it another way ?
Pictures 3-4 ........Long neck vessel with a small finial - now complete
Picture 5 -Small vessel complete - now it has a finial
Picture 6 .......Natural Edge Small bowl - Sanded to 400 and 2 coats of DO, now sitting and drying.
Questions - I usually use my Ci1 to clean up the bottom nub on the inside of the vessels which is quick and easy to do......anybody else doing it another
way?
I have been using a Mandrel to reverse and part off.......how is everybody else doing it ? (see Picture 7)
Prior to turning any of the natural edge pc's I have been putting CA glue on the bark near the middle to help hold it in place. Then making my
cuts away from the natural edge............anyone else doing it another way ?
Attachments
Last edited: