- Messages
- 20,173
- Location
- Springfield, Missouri
Darren, it's looking good. Did you put a srew up from the bottom on the articulating lamp? I have a lamp just like that. I bought it at a garage sale for .25 cents. I want to use it over my lathe but it also needs to be mounted like that.
No, It's the shiny screw just above the block in the pic below. It was just a quick fix as I needed something to keep it from pulling up out of the cleat. If I had made the holder a little taller than the wall cleat, then I could use the double headed nails like Glenn uses that pin the block in without making more screw holes.
Edit: I think you meant into the bottom of the lamp, but no to that as well, just a 1 1/4" deep 1/2" hole, gravity holds it pretty well.