Ron Roase
Member
- Messages
- 268
- Location
- Bloomington MN USA
Just would like to know how most of you rip bevals on a table saw? If the blade tilts to the right,do you have the rip fence to the right or the left of the blade? I have found that if I have the fence to the right on a 45* rip when putting the beval on both sides of the board,the thin edge wants to creep under the fence. So I have been putting the fence to the left of the blade so the thin edge is in better contact with the fence. Is this a safe practice or am I an accident witing to happen.