I have a giveaway. Will there be takers?

Frank Fusco

Member
Messages
12,782
Location
Mountain Home, Arkansas
I have about 50 blades for a Scintilla jig saw. These are made in Switzerland. There are all kinds. Plus there is a guide wheel for a Scintilla saw.
Back in the early days, when folks were starting to leave the Neanderthal ways, the first recip/jig saw on the market was the Scintilla. And for many years that is how that type of saw was commonly referred to. These are among my inherited 'stuff'. I don't need them. I discarded the Scintilla saw I inherited. :eek:
I'll send to first responder who says he can use them.
 

Attachments

  • Scintilla blades.jpg
    Scintilla blades.jpg
    137.7 KB · Views: 84
Frank, I do not need them but am wondering if the blades will fit a modern saw
 
OK, sometime today or tomorrow they go in trash. I need the storage drawer they were in.
BTW, I tossed my Scintilla saw for two reasons, make that three.
It was very heavy. It smoked in use. It didn't have a handle, you held by the body which, of course, contained the motor that got real hot, real fast, very hard to hold for more than about two minutes.
 
I do not have this saw either but will take the blades to make tools for my lathe if you still got them
 
Top