Rick Levine
Member
- Messages
- 91
I recently purchased a Nova Live Center System for my Delta model 46-715 lathe and discovered that the knock out rod that comes with the lathe will not remove the live center.
The hole through the headstock is too narrow to fit the required 1/2" rod that matches the hole in the end of the live center. If I try to plug the end of the live center I then can not knock out the replaceable tips for the center.
Does anyone have a solution to the problem other than returning the live center?
The hole through the headstock is too narrow to fit the required 1/2" rod that matches the hole in the end of the live center. If I try to plug the end of the live center I then can not knock out the replaceable tips for the center.
Does anyone have a solution to the problem other than returning the live center?