larry merlau
Member
- Messages
- 18,741
- Location
- Delton, Michigan
ok chuck, brought up a good question, why not use router bits in a shaper?
is the 10,ooo rpm not enough to use smaller bits in a shaper? is there anyone out here that has done it, and if so what is your opinion on the outcome? what tooling is needed to get the shaper to accept the router bits?
is the 10,ooo rpm not enough to use smaller bits in a shaper? is there anyone out here that has done it, and if so what is your opinion on the outcome? what tooling is needed to get the shaper to accept the router bits?