Peter Lyon
Member
- Messages
- 330
- Location
- Puyallup, WA
I need to spray water based white pigmented lacquer this weekend on some cabinet doors. The frames are bare poplar and the panels are prepainted (white) beadboard material I purchased from Depot.
I would like to use an HVLP gun for this but unfortunately the one I've owned for a few years met its untimely demise this past summer (it was knocked off the hook it hangs from on to the concrete floor ). Can anyone recommend an inexpensive (yet ultimately effective) unit to replace my broken one?
Ideally it would be one from Harbor Freight (due to cost and convenience) but perhaps that's too much to ask for.
I own a fairly decent sized compressor so I don't have to go the turbine route if that helps any.
I would like to use an HVLP gun for this but unfortunately the one I've owned for a few years met its untimely demise this past summer (it was knocked off the hook it hangs from on to the concrete floor ). Can anyone recommend an inexpensive (yet ultimately effective) unit to replace my broken one?
Ideally it would be one from Harbor Freight (due to cost and convenience) but perhaps that's too much to ask for.
I own a fairly decent sized compressor so I don't have to go the turbine route if that helps any.