Results 1 to 3 of 3

Thread: Steaming out a dent

  1. #1
    Join Date
    Oct 2006
    Central NY State

    Steaming out a dent

    No, it isn't Car Talk.
    I got the idea to do this from Bill Satko, who reminded me that itís really easy to put a dent in soft secondary wood.

    So imagine youíre proud of your new dovetails, until you see this nice dent on one, that happened as you banged them out, when a small chip was under the soft wood.

    The solution: steam out the dent.

    Hereís the equipment needed Ė water, paper towel, and a household iron.

    DO NOT, I repeat, DO NOT use your honeyís iron for this. The way to get an iron is to offer to buy LOYL a new iron, and you get to keep the old one. Win, win.

    First spray a little water on the dent, maybe a teaspoon or so. Then place the paper towel, folded up over it, and saturate the towel with the sprayer.

    Wait til your iron is hot, I use whatever the maximum setting is. [The OCD scientist in me had to put temp readings on the iron, but that is totally unnecessary.]

    Then, strike while the iron is hot. A nice ball of steam comes out with a hiss. Firm pressure is good.

    After as many repeats of this procedure as you need, you will have raised the dent above the surface of the wood.

    Let this dry out for a while. Maybe use a heat gun or the iron dry, or just wait, then plane smooth. The result should look like this.

    Practice on scrap before you tackle a real job. It's a great fix for a common problem. - With thanks to Tage Frid, who wrote about this in his book.

  2. #2
    Join Date
    Jun 2010
    Vancouver Island, Courtenay/Comox Valley, British Columbia
    That's great Ken. I'd just like to add when you buy the LOYL a new iron, get him or her a Rowenta (the best by a country mile) or a Panasonic if you want a good iron that's much cheaper.
    AKA Young Grasshopper Woodworker
    AKA The Rookie

  3. #3
    Join Date
    Jul 2009
    Amherst, New Hampshire
    I've heard of that but never thought it would work. Fantastic tip Ken
    Faith, Hope & Charity

Similar Threads

  1. Dent Steaming?
    By larry merlau in forum General Woodworking Q&A
    Replies: 2
    Last Post: 07-11-2012, 03:53 PM
  2. Steaming out a dent - tutorial
    By ken werner in forum Neander Woodworking Q&A
    Replies: 5
    Last Post: 08-11-2011, 03:38 AM
  3. Steaming out a dent in veneer?
    By Paul Downes in forum General Woodworking Q&A
    Replies: 6
    Last Post: 12-03-2010, 04:40 PM
  4. Steaming out a dent - tutorial by Ken Werner
    By ken werner in forum Tips and Tutorials
    Replies: 0
    Last Post: 11-21-2010, 05:24 PM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts