Chris Hatfield
Former Member (by the member's request)
- Messages
- 380
My wife wants a wish list, and I'm filling some rather extravagant wants here. I mean, surely a mortise machine can fit into a stocking, right?
But actually I was looking at the three pack of nailers from Harbor Freight that's on sale for $50 this month with coupon. I'm not really looking for opinions on that particular set, but you're welcome to give them.
I've been borrowing a nailer from someone that came in a set, and I'm not getting great results from it. The hole the brad makes is elongated horizontally. They are 18-ga brads used in a Husky 2n1 nailer/stapler. I'm pretty sure I'm using the right nail in the nailer, so I don't think that's the problem. Is that how it normally works, and for anything where I don't want holes to show use a pin nailer, or is something wrong somewhere in the process?
But actually I was looking at the three pack of nailers from Harbor Freight that's on sale for $50 this month with coupon. I'm not really looking for opinions on that particular set, but you're welcome to give them.
I've been borrowing a nailer from someone that came in a set, and I'm not getting great results from it. The hole the brad makes is elongated horizontally. They are 18-ga brads used in a Husky 2n1 nailer/stapler. I'm pretty sure I'm using the right nail in the nailer, so I don't think that's the problem. Is that how it normally works, and for anything where I don't want holes to show use a pin nailer, or is something wrong somewhere in the process?