Stuart Ablett
Member
- Messages
- 15,917
- Location
- Tokyo Japan
Early in the new year I will be tasked with building a new stand up cigar humidor for the liquor shop. The cash register area is going to get a $50,000 facelift, and part of that will be a new cigar humidor. We are not paying for this, one of the tobacco companies is We are also getting a new sign for the shop out front too. They were going to provide humidor, but it was a particle board and plastic piece of poor quality junk that I would never put quality cigars into, they would smell like plastic and glue in a week
The new humidor will be kind of like a China Cabinet, if that makes sense.
Some ideas.
My first question is can anyone recommend a rail and stile bit set for glass doors?
I'm looking hard at the new Freud set, this one >> Freud 99-763 << with the optional cutter for glass doors, I'm not sure if this is any good, but I figure it is not bad.
Any opinions out there?
Cheers!
The new humidor will be kind of like a China Cabinet, if that makes sense.
Some ideas.
My first question is can anyone recommend a rail and stile bit set for glass doors?
I'm looking hard at the new Freud set, this one >> Freud 99-763 << with the optional cutter for glass doors, I'm not sure if this is any good, but I figure it is not bad.
Any opinions out there?
Cheers!
Last edited: