Julio Navarro
Member
- Messages
- 281
- Location
- Tampa
I am working on the edge portion of the panel construction. The piece that mates on to the bead that runs the length of the board. But I keep getting an uneven cut that leaves one side thicker than the other.
The picture shows what I mean.
I am assuming my router table is not level, so, tomorrow I will be doing some re thinking about my table.
Can someone confirm this is indeed the cause of the problem?
The picture shows the top edge of the rail is just a bit thinner at one end. The picture is a little out of focus but you can still see the unevenness.
The second image is the style showing the bead. You can see some of the burn from the bit when I was changing hands as I pushed one piece through...darn it.
The picture shows what I mean.
I am assuming my router table is not level, so, tomorrow I will be doing some re thinking about my table.
Can someone confirm this is indeed the cause of the problem?
The picture shows the top edge of the rail is just a bit thinner at one end. The picture is a little out of focus but you can still see the unevenness.
The second image is the style showing the bead. You can see some of the burn from the bit when I was changing hands as I pushed one piece through...darn it.