Julio Navarro
Member
- Messages
- 281
- Location
- Tampa
I have a Hitachi (strongly regret it) TS whose blade tilts to the left.
I have a 4" wide board about 24" long that I need to put a 45º bevel on one edge.
How do I rip the 45º angle, with the wood on the right side of the blade (cutting from underneath) or the left side (cutting from top)?
Thanks guys.
I have a 4" wide board about 24" long that I need to put a 45º bevel on one edge.
How do I rip the 45º angle, with the wood on the right side of the blade (cutting from underneath) or the left side (cutting from top)?
Thanks guys.