Not woodworking but shop work

Chuck Thoits

Member
Messages
4,045
Location
NH
Tonight's labors in the shop.
I had an order for 10 of these last weekend so tonight was the night to get-r-done.
The last pick is of all but 5 of last years unfinished stock finished up and ready for sale this weekend.:thumb:
The last 5 are not going to get finished unless a custom order for burning comes in.:thumb:
The seventh pic is of that bent up window control arm for the jeep. It hung out in the forge for a few minutes and I straighten it right out good as new.
 

Attachments

  • tn_pegs 002.JPG
    tn_pegs 002.JPG
    51.2 KB · Views: 70
  • tn_pegs 003.JPG
    tn_pegs 003.JPG
    69.4 KB · Views: 69
  • tn_pegs 004.JPG
    tn_pegs 004.JPG
    74 KB · Views: 66
  • tn_pegs 005.JPG
    tn_pegs 005.JPG
    73.8 KB · Views: 67
  • tn_pegs 006.JPG
    tn_pegs 006.JPG
    70.6 KB · Views: 68
  • tn_pegs 007.JPG
    tn_pegs 007.JPG
    62.5 KB · Views: 69
  • tn_pegs 008.JPG
    tn_pegs 008.JPG
    68.8 KB · Views: 68
  • tn_pegs 001.JPG
    tn_pegs 001.JPG
    88.5 KB · Views: 73
Last edited:
oh if i only had time and space,, that forge is sweet chuck..and they wont have to worry about them stakes breaking..can almost smell the coke from the old days but hey hot metal is close enough to the same feeling:)
 
Didn't know you liked to work with a forge Larry. I have two, plans are to set them up in the metal shop we discussed.
Scares me I could read Chuck's mind!!! :rofl::rofl::rofl: I think they will do the job Chuck. :thumb::thumb:
 
Top