Bart Leetch
Member
- Messages
- 3,206
I have seen a fence that is fastened down on the out feed end with a pivot pin & you just move the in feed end to the position needed depending on the work your doing. I have never talked to anyone that has one to find out how well it works though.
Has anyone else seen a fence like this or heard how well it works.
My thoughts are that the out feed end would have to have a pin in the bottom of the fence & an insert in the table for the pin to go into, if you want to have a clear table when the fence is removed. Also the way this system measures distance from the cutter is in an arc so this may be a little more difficult to set up if you want a direct reading scale right on your router table.
Here are a couple of URL's that help show this type of fence.
http://www.tunelab-world.com/routerscale.pdf
http://www.google.com/url?sa=t&sour...sg=AFQjCNGlvQXeWrOGsNbunFzDCkQgDrwjww&cad=rja
Has anyone else seen a fence like this or heard how well it works.
My thoughts are that the out feed end would have to have a pin in the bottom of the fence & an insert in the table for the pin to go into, if you want to have a clear table when the fence is removed. Also the way this system measures distance from the cutter is in an arc so this may be a little more difficult to set up if you want a direct reading scale right on your router table.
Here are a couple of URL's that help show this type of fence.
http://www.tunelab-world.com/routerscale.pdf
http://www.google.com/url?sa=t&sour...sg=AFQjCNGlvQXeWrOGsNbunFzDCkQgDrwjww&cad=rja