Jim O'Dell
Member
- Messages
- 2,783
- Location
- Between Aledo and Fort Worth, TX
I don't need a real expensive one, but something more than what I had. It was a Christmas gift from LOML. Found the cheapest one she could find at a B&D outlet store at the outlet mall. It worked and did ok, but recovery time was 15 minutes for every 5 minutes of use. I've searched through the archive here and gotten some information. Specifically I'm looking at the Milwaukee 3021-21, the Bosch ROS20VSK, the DeWalt D26451K, and at the higher end, a refurbished Ridgid 2610. The Ridgid is a 6" unit made by Metabo, and has the switchable 1/8" and 1/4" pattern for sanding. I have a Ridgid 4" angle grinder that is the Metabo build and it is a hoss. Anyone have any personal info on any of these units? Pros and cons would be very helpful! Thanks. Jim.