Sandy Navas
Member
- Messages
- 52
- Location
- St. Joseph, MO
I am not a total newbie to turning - first turned on (and probably ruined) my Dad's lathe when I had to pull up a Pepsi case to reach the on/off switch. I've been turning spinning tops recently and would really like to find a chuck similar to a drill press chuck that would screw onto the headstock (approximately 1/2 inch opening only).
Before I begin a fruitless search, has anyone ever seen something like this? I have a regular drill chuck but need the tailstock in place to use it on the headstock.
Before I begin a fruitless search, has anyone ever seen something like this? I have a regular drill chuck but need the tailstock in place to use it on the headstock.