Rob Keeble
Member
- Messages
- 12,633
- Location
- GTA Ontario Canada
I need some help and advise please.
I am putting up a small fence and couple of gates on the side of the house to close off the passageway to the back leading directly to my shop.
So i have worked out a design to match the fence but cannot decide which way to lay the 2x4 lumber in the gate.
Here is a picture of what i have in mind. There are to be two gates both the same just a mirror of each other.
Which way would be best and why? A or B
Oh and gates will hang off a 6x6 post.
Thank you in advance for any tips help or advice.
You guys have any preference for hinges. One gate is gonna flip inward 90 degrees against the fence running down to the shop and the other is gonna do a 180 degree flip inward against the remaining bit of fence the same width as the gate.
I am putting up a small fence and couple of gates on the side of the house to close off the passageway to the back leading directly to my shop.
So i have worked out a design to match the fence but cannot decide which way to lay the 2x4 lumber in the gate.
Here is a picture of what i have in mind. There are to be two gates both the same just a mirror of each other.
Which way would be best and why? A or B
Oh and gates will hang off a 6x6 post.
Thank you in advance for any tips help or advice.
You guys have any preference for hinges. One gate is gonna flip inward 90 degrees against the fence running down to the shop and the other is gonna do a 180 degree flip inward against the remaining bit of fence the same width as the gate.
Last edited: