- Messages
- 16,546
- Location
- Reno NV
So, you may or may not remember the previous incarnation of my edge guide ripper. It was really rudimentary but made quick work of breaking down sheet goods for use in making shelves and cabinets.
In the October 2011 issue of Wood Magazine, they had something pretty similar, but way more useful, so I went ahead and made myself one.
I used some leftover vinyl faced hardboard that I used on my garage counter tops and some plywood and a chunk of 2x4. But now it's much easier to setup.
I had bought some of that Red Tape and used that to put a measuring rule on it.
Still rudimentary, but it should work pretty well.
In the October 2011 issue of Wood Magazine, they had something pretty similar, but way more useful, so I went ahead and made myself one.
I used some leftover vinyl faced hardboard that I used on my garage counter tops and some plywood and a chunk of 2x4. But now it's much easier to setup.
I had bought some of that Red Tape and used that to put a measuring rule on it.
Still rudimentary, but it should work pretty well.