FREE..... 3/4 inch stainless steel round bar for making hollowing tools or anything

Tom Baugues

Member
Messages
2,790
Location
Lafayette, Indiana
At my day job I repair and rebuild manufacturing machines. When doing so I often replace "worn out" stainless steel shafts. Worn out usually means very minor surface wear that can usually be buffed out with emery cloth. Some are 1/2 inch some 3/4 inch alot of metric sizes as well. This week I replaced some 3/4 inch shafts. Each shaft is 17 inch's long. I have used these for making myself a good assortment of cutting tools for my hollowing set up. I do not need these shafts. If anyone here wants one or two or all....you can have them for the cost to ship them to you. I can get pictures and exact length tomorrow. If any one would like these please let me know.
100_0581 (Small).JPG
100_0582 (Small).JPG
 
Last edited:
Are they all spoke for? I'd be interested in two for a project. Size doesn't mater other than they match. If not keep me informed of any in the future.
 
Top