Doug DeVore
Member
- Messages
- 106
- Location
- Southern, Illinois
Hey all-
Project coming up were I will need to cut lots of sheets goods and was wondering what everyone else does? Right now, I usually rough cut using a circular saw & guide and then finish cut on the table saw if the piece is small enough. Every now and then I will cut them on my table saw, but my shop is not big enough to do this on a regular basis (7' ceilings, etc.). I am thinking about pulling the trigger on a festool setup. Sure would be nice, but ouch the price is a little high. Other ideas?
Sure would be nice to find something that is as fast and easy to use as a table saw....maybe I just need to invest some time into creating large infeed and outfeed tables.
Project coming up were I will need to cut lots of sheets goods and was wondering what everyone else does? Right now, I usually rough cut using a circular saw & guide and then finish cut on the table saw if the piece is small enough. Every now and then I will cut them on my table saw, but my shop is not big enough to do this on a regular basis (7' ceilings, etc.). I am thinking about pulling the trigger on a festool setup. Sure would be nice, but ouch the price is a little high. Other ideas?
Sure would be nice to find something that is as fast and easy to use as a table saw....maybe I just need to invest some time into creating large infeed and outfeed tables.