Rockler Aluminum Router Lift FX

Roger Pozzi

Member
Messages
75
Location
Mount Vernon, Ohio
This lift is sale priced here: http://www.rockler.com/product.cfm?...2364e24a9-48FC41E2-D4A5-4E59-2B336D84E59B32FA ,almost within my budget until Feb. 8th.
Does anyone have experience with this lift ? Or thoughts about it's quality and usefulness ?
I am using a Bosch 1617 with the standard base in my table right now but, this seems like it could be much more precise and easier to use plus allowing above the table bit changes.
Any thoughts would be appreciated.
 
I don't have experience with that particular lift but that is an excellent price. I have a Jessum lift and a lift makes a world of difference over a router attached to a plate when you're adjusting the bit height. :thumb:
 
that is a good deal, from what i can see.. i paid half that just for a attachment that acts like a lift with a plunge router.. if i were in the market and it accepted a larger router i would think hard on it but it fits your router just fine from what the manual says..
 
Top