keith Boutselis
Member
- Messages
- 208
- Location
- central florida
Hi all;
This is kinda about the same piece of equipment I am probably going to buy, my 20" dewalt ras, but I have been alerted to a potential problem.
I was laboring under the assumption that i could use a 12" blade any time I wanted.
I have since been told that the saw may not have enough rpm for a 12" blade. the motor says rpm 2825/3425. it is set up for 20" but will it cut ok with a 12" if I need it too?
This is kinda about the same piece of equipment I am probably going to buy, my 20" dewalt ras, but I have been alerted to a potential problem.
I was laboring under the assumption that i could use a 12" blade any time I wanted.
I have since been told that the saw may not have enough rpm for a 12" blade. the motor says rpm 2825/3425. it is set up for 20" but will it cut ok with a 12" if I need it too?