Roger Ruchti
Member
- Messages
- 4
- Location
- SW Iowa USA
Purchased this item recently and believe I got about everything that was supposed to be with it originally, plus some extra. One item I am short is the operators manual. I tried using the manual for a later model but it has different features for adjusting the feed system. If anyone would happen to have a manual for this filer I would be gland to compensate them for a copy of the pages that show the feed system adjustment.
On another note, I also received 5 additional bars that I believe may go to a machine that cuts new teeth in a hand saw. Each bar is 1/4" X 5/8" X 38 1/4" long. They all have flat topped teeth on the one edge of the bar of different sizes. On top of each bar near the end is a number: 7-4; 8-4 1/4:9-5; 10 - 5 1/2; 11-6. I have no idea what these numbers mean but I bet one of you guys would know. I don't think I have any use for them so if you know what they are for and have a use for them, they could be bought at a reasonable price.
Thanks much for any help you can shed.
Rog
On another note, I also received 5 additional bars that I believe may go to a machine that cuts new teeth in a hand saw. Each bar is 1/4" X 5/8" X 38 1/4" long. They all have flat topped teeth on the one edge of the bar of different sizes. On top of each bar near the end is a number: 7-4; 8-4 1/4:9-5; 10 - 5 1/2; 11-6. I have no idea what these numbers mean but I bet one of you guys would know. I don't think I have any use for them so if you know what they are for and have a use for them, they could be bought at a reasonable price.
Thanks much for any help you can shed.
Rog