It looks great - I started with a coffee table, which I wish looked as good as yours.
If those are truly breadboard ends, and the pegs in the ends are in oval holes, that is doubly amazing for a first project. Hopefully you attached the aprons to the breadboard end, so the grain is going in the same direction.
I am concerned about the wood movement across the grain - I saw pictures on another forum a few years ago, where the cross braces, glued and screwed to the bottom of a table, tore the table apart as the wood shrank. It didn't have breadboard ends, but those will keep the ends of the boards aligned and pretty, but will not keep them from expanding and shrinking. Rule of thumb - count on at least 1/8 inch expansion and contraction in each foot of cross grain, and close to no change in the long grain. No amount of finish or glue will prevent that wood movement.
Sorry to be such a wet blanket on your first project. It looks great.
Now add a drawer!