Jake Vrbka
Member
- Messages
- 35
- Location
- Malcolm, NE
So I'm in the process of building a kitchen table. I'm using pine, and am wondering about how to finish it. I was thinking of using a pre stain wood conditioner, then 2-3 coats of stain, then a sanding sealer, after that I'm not so sure. I read about using 4-5 coats of General Arm R Seal, but I was looking at their website and the place they have listed that sells it is over 60 miles away. Any other ideas? I'm planning on using a couple light coats of briwax on top of everything.
I've never really done much finishing other than just staining, so any ideas or thoughts are greatly appreciated!!
I've never really done much finishing other than just staining, so any ideas or thoughts are greatly appreciated!!