Stuart Ablett
Member
- Messages
- 15,917
- Location
- Tokyo Japan
In this thread......... HERE ......... I talk about the rebuild of the old 1963 drill press I got.
I hated the cover that someone had fabricated for it, so I left it off, this, was not the best situation, so I made a new hat for Kermit............
I took a cheap SS bowl and cut it in half, then put a piece of sheet metal on the bottom and attached it to Kermit.
This should keep my fingers out of the pulley
More to do on Kermit, but I've been busy, this one was done, as I like being able to count to ten on my fingers
Cheers!
I hated the cover that someone had fabricated for it, so I left it off, this, was not the best situation, so I made a new hat for Kermit............
I took a cheap SS bowl and cut it in half, then put a piece of sheet metal on the bottom and attached it to Kermit.
This should keep my fingers out of the pulley
More to do on Kermit, but I've been busy, this one was done, as I like being able to count to ten on my fingers
Cheers!