Bill McQueen
Member
- Messages
- 140
- Location
- Lincoln AR
Hoping not to open a can of worms here.
I making some of my own edge banding and I need a new bandsaw blade. I'm working with hardwood around 1-2 1/2 inch high. I have a 931/2 6 tpi on it now and it works ok, just worn out.
I would put the same thing on it but it seems (scary word) that since I'm not going through so much materal (like cutting logs) that maybe less teeth would work. I think what I'm been using 1/2 X.25 x6 is still ok I just thought I run it by you guys about the teeth, skip. raker etc.
I wanted to hold back on the big offset because I'm trying to cut from 1/8 down to 1/16.
I don't want to start a brand war, but what works FOR YOU might work for me.
Thanks
I making some of my own edge banding and I need a new bandsaw blade. I'm working with hardwood around 1-2 1/2 inch high. I have a 931/2 6 tpi on it now and it works ok, just worn out.
I would put the same thing on it but it seems (scary word) that since I'm not going through so much materal (like cutting logs) that maybe less teeth would work. I think what I'm been using 1/2 X.25 x6 is still ok I just thought I run it by you guys about the teeth, skip. raker etc.
I wanted to hold back on the big offset because I'm trying to cut from 1/8 down to 1/16.
I don't want to start a brand war, but what works FOR YOU might work for me.
Thanks