allen levine
Member
- Messages
- 12,370
- Location
- new york city burbs
seems no matter what speed I set my router to, no matter what feed rate I use, Im getting splintering with both the rail end cutter and sometimes with the raised panel bit.
I ran a piece of spanish cedar out of curiosity, and it ran through smooth.
I had some problems with the ash also.
I cleaned the bits, tried a few different speeds, and tried adjusting the rate at which I fed it, so is it just cherry, or is it just my cherry, or is it just me?
any tidbits of advice are greatly appreciated.(I had to junk a few sections of stiles, and some of my raised panels splintered on the edges, so I just sanded them down, it wont be seen inside the stile mortises, but Id rather have smooth cuts)
I ran a piece of spanish cedar out of curiosity, and it ran through smooth.
I had some problems with the ash also.
I cleaned the bits, tried a few different speeds, and tried adjusting the rate at which I fed it, so is it just cherry, or is it just my cherry, or is it just me?
any tidbits of advice are greatly appreciated.(I had to junk a few sections of stiles, and some of my raised panels splintered on the edges, so I just sanded them down, it wont be seen inside the stile mortises, but Id rather have smooth cuts)