Bart Leetch
Member
- Messages
- 3,206
Well I was working at my Dad's combination Jointer/Table-saw they are close together (to close for comfort) & run by a common motor . I using the jointer & it is crowded so I was standing behind & a little to the right of the jointer & as I moved my right hand came into contact with the table-saw blade. just nicking the index finger nail inside edge & getting the middle finger about where a pencil would rest when writing & the ring finger at the left side of the nail. The fingers work ok the Dr. says I may lose a little feeling in the middle finger tip the nerves can be operated on but it probably wouldn't get the results we are looking for.
After thought it would pay to roll the TS blade down when running the jointer.
Pics not good but here they are.
After thought it would pay to roll the TS blade down when running the jointer.
Pics not good but here they are.
Attachments
Last edited: