Yes...it's thin enough!

Jim Burr

Member
Messages
3,633
Location
Reno, Nv
It's hard to tell by the photo, but the wall on this pen at the bushing end is 1/32" thick. For a metal sandwich and spalted wood...that wasn't the best idea I've ever had:rolleyes:...but it held up! Gold and black Ti Elegant Beauty from Berea. Wood is spalted something with a copper inlay and 10 coats of thin CA and polished with Hutts. I really wanted a Jr Gent out of it, but after all was said and done...wasn't going to happen:(. Swap pen for an IAP event, hope they like it and thanks for looking!:D
 

Attachments

  • swap1.jpg
    swap1.jpg
    108.5 KB · Views: 49
  • swap2.jpg
    swap2.jpg
    107.8 KB · Views: 62
  • swap3.jpg
    swap3.jpg
    54 KB · Views: 58
Thanks guys...I still like aluminium better, but I have a lot of copper. Copper only flys with goldish kits where aluminium goes with silver, platinium, black Ti, so on. I have an idea for another one that's never been done before so that'll start when a commission job is done.
 
Top