allen levine
Member
- Messages
- 12,369
- Location
- new york city burbs
is this a mistake?
I havent touched my lathe in well over a year, maybe more like 2? not sure.
Even though I have it mounted on a mobile table, I have to spin the table around and move all the other machines in the garage to access it, so I just dont.
I have a small extra bedroom, that is currently my finish room,(but the room is hardly used as a finish room) not worried about dirtying or whatever in there, but Im concerned about getting dust and chips tracking throughout the entire house.
The room has a brand new AC,naturally its heated, so I can try turning again,anytime, or should I say, start turning, during an evening, whenever, the noise wouldnt bother my wife whos upstairs.
is this something Im going to regret? too messy for in home? Id clean up the mess each time I use it, as to avoid most of the dust going anywhere.
anyone have a lathe in their homes? not garage or basement?
I havent touched my lathe in well over a year, maybe more like 2? not sure.
Even though I have it mounted on a mobile table, I have to spin the table around and move all the other machines in the garage to access it, so I just dont.
I have a small extra bedroom, that is currently my finish room,(but the room is hardly used as a finish room) not worried about dirtying or whatever in there, but Im concerned about getting dust and chips tracking throughout the entire house.
The room has a brand new AC,naturally its heated, so I can try turning again,anytime, or should I say, start turning, during an evening, whenever, the noise wouldnt bother my wife whos upstairs.
is this something Im going to regret? too messy for in home? Id clean up the mess each time I use it, as to avoid most of the dust going anywhere.
anyone have a lathe in their homes? not garage or basement?