Results 1 to 1 of 1

Thread: shaper

  1. #1
    Join Date
    Mar 2008
    Winchester Ky.


    SOLD I have an old craftsman shaper. This is the one with the cast iorn open table. I believe it hasa 1/2 inch spindle. This is a project. I know the motor is burnt out. The spindle seems to turn freely and it works up and down smoothly. there is a few spots of surface rust on the table but it will clean up good. with a little TLC it would make a good tool. $50.00. You may have noticed I have listed a couple of other tools for sale, there is a new project on the way and I am needing to make room in my shop. . 859 771 4304
    Last edited by ken lutes; 08-29-2012 at 12:01 AM.

Similar Threads

  1. Little shaper
    By Rennie Heuer in forum Old Iron
    Replies: 6
    Last Post: 07-06-2015, 03:29 PM
  2. my jet shaper
    By Dan Noren in forum Old Iron
    Replies: 18
    Last Post: 08-20-2009, 11:04 PM
  3. shaper platform
    By Dan Noren in forum Flatwork Project Showcase
    Replies: 1
    Last Post: 08-15-2009, 08:56 AM
  4. C-Man shaper
    By Al killian in forum Old Iron
    Replies: 4
    Last Post: 10-27-2008, 09:03 PM
  5. Shaper Question.
    By George Blevins in forum New Tools
    Replies: 22
    Last Post: 04-14-2007, 01:19 AM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts