Mike Turner
Member
- Messages
- 361
- Location
- Laurinburg NC
I make flutes as a hobby. I use a drill press and have tried some different ways of placing the finger holes accurately in line on these flutes. It is so easy to get "off". I though about getting a bench top milling machine which some makers use but wish there was a cheaper way that was still accurate.. A bench top milling machine on the cheap is still $700 to $800 plus all the necessities.. (My drill press is not the best but works) Ive been looking at Craigslist and have actually posted an ad wanting to do a swap/trade for some things I have...some nice deer hunting stuff and some other odds and ends...Any ideas on the placement of these holes??? Thanks!