Guy Bratt
Member
- Messages
- 64
- Location
- Richmond, MI near Port Huron
Hello I usually visit the woodturning forum. I have been issued a request by my wife to make her a sewing table/cabinet.
The plan I have consists of a carcas with a faceframe front. The plan was apparently designed to stay with it's back to a wall. It was open in the back.
I want a closed back with out exposed raw plywood edges. This is my first furniture type project. What would be my best plan to join the side and back sheets with out showing a raw edge? Thanks in advance. Guy
The plan I have consists of a carcas with a faceframe front. The plan was apparently designed to stay with it's back to a wall. It was open in the back.
I want a closed back with out exposed raw plywood edges. This is my first furniture type project. What would be my best plan to join the side and back sheets with out showing a raw edge? Thanks in advance. Guy