Mohammad Madha
Member
- Messages
- 2,700
- Location
- Los Angeles, CA
Some time ago I bought a shopfox mobile base (G7315z) for my bandsaw. Well, I finally decided to assemble it. I noticed that all the rails only had one hole. My grizzly tablesaw is also on a mobile base and on that base there are two threaded holes on the top on each side of the rails and the bolts go thru the holes on the corner bracket and the holes on the rails.
I took some pictures and emailed Grizzly's support. Their response was that the bolts just go thru the corner bracket holes and apply pressure on the rails. The one hole on the rails is for shopfox to hang them with and apply spray paint.
Is this setup going to be secure enough while moving the machine on the base?
I took some pictures and emailed Grizzly's support. Their response was that the bolts just go thru the corner bracket holes and apply pressure on the rails. The one hole on the rails is for shopfox to hang them with and apply spray paint.
Is this setup going to be secure enough while moving the machine on the base?