Results 1 to 3 of 3

Thread: How would I accomplish this?

  1. #1
    Join Date
    Nov 2010
    Location
    Richmond, MI near Port Huron
    Posts
    64

    How would I accomplish this?

    What I'd like to do is turn a bowl from a board. I've done this before so I know how to line my cuts for the bowl part.
    What I'm trying to do is add a wedge to the primary stock. I don't have a jointer to angle the board. My stock would be 8 to 10 inches square. I'm looking for suggestions as to how I can make the wedges flat for glue up. I've included a drawing of what I what to do. Glue red to blue.bowl_board2.skp I hope this shows up

  2. #2
    Join Date
    Nov 2006
    Location
    Austin, Texas
    Posts
    1,448
    I don't currently have sketchup installed on my active computer, but if you can export the picture you want us to look at as a jpg, I would be glad to try to help you.
    Charlie Plesums, Austin Texas
    (Retired early to become a custom furnituremaker)
    Lots of my free advice at www.solowoodworker.com

  3. #3
    Join Date
    Nov 2010
    Location
    Richmond, MI near Port Huron
    Posts
    64
    I'll try again this weekend thanks

Similar Threads

  1. What is the best way to accomplish this #2.
    By Kevin Reid in forum General Woodworking Q&A
    Replies: 5
    Last Post: 12-16-2009, 11:11 PM
  2. What is the best way to accomplish this?
    By Kevin Reid in forum General Woodworking Q&A
    Replies: 16
    Last Post: 12-16-2009, 10:05 PM
  3. So ...what did you accomplish in the shop this weekend
    By Rob Keeble in forum Off Topic Discussion
    Replies: 20
    Last Post: 10-21-2008, 12:40 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •