Rex Bloem
Member
- Messages
- 439
I know that I haven't posted much lately. I have been very busy with work and just not in the woodworking mood. I did purchase a 50" rail set for my table saw. I am going to put a router table in the right hand end of it. I got some solid surface material at an auction and I am thinking of using for the route top. What I need to know is what should I use for adhesive to glue it to a piece of 3/4" partitical board. The surface material is 1/2" thick and needs a little beefing up. I will also put stringers on the bottom near the hole to help keep it level. What are your thoughts.