jim capozzi
Member
- Messages
- 280
- Location
- oswego county , upstate n.y.
hi all
ok one more question
i was reading the book that came with my vac. press . it said to make your cauls the same size as your project if you were working with 1/8" or 1/4" sheet goods. the book didn't say anything about 1/2 or 3/4 plywood , do i also have to size these cauls the same way . to my little brain this seems incredibly wasteful and could get insanely expensive after a very short time . if i use 3/4 baltic birch ply is this still the rule? i cut it to a managable size for my platten board and a top caul , both are 30x30. if i use these for smaller projects will it work or will they bubble or not seal the veneer in the middle of the piece ?
thanks for the help AGAIN!
ok one more question
i was reading the book that came with my vac. press . it said to make your cauls the same size as your project if you were working with 1/8" or 1/4" sheet goods. the book didn't say anything about 1/2 or 3/4 plywood , do i also have to size these cauls the same way . to my little brain this seems incredibly wasteful and could get insanely expensive after a very short time . if i use 3/4 baltic birch ply is this still the rule? i cut it to a managable size for my platten board and a top caul , both are 30x30. if i use these for smaller projects will it work or will they bubble or not seal the veneer in the middle of the piece ?
thanks for the help AGAIN!