Results 1 to 6 of 6

Thread: some nice items at reasonable prices

  1. #1
    Join Date
    Oct 2006
    Location
    Central NY State
    Posts
    3,362

    some nice items at reasonable prices

    I've decided to upgrade some of my tools, and have the following items for sale:

    1/4" - 1" 7 piece set of Grizzly forstner bits, in a nice wooden box. 1/8" increments. Good condition, but certainly used. Recently sharpened. These are made in Taiwan, and a cut above the usual made in [mainland] China stuff. $12 shipped to the lower 48.

    1/8 - 1/2" set of brad point bits, in 1/16" increments. 7 in all. 3/8" round shanks. Made in Germany. Again, better than the cheap stuff out there, but not the equal of the LV set that will replace them. No case. $12 shipped to the lower 48.

    A pair of French made brad point bits, 3/16" and 1/4" each in its own protective tube. Very nice quality, and little used. I saved these for "special holes" to keep them quite sharp. $6 shipped for the two.

    Veritas striking knife. Good condition, used. Honed. Sells for $24.50 new. See it here:
    http://www.leevalley.com/wood/page.a...936,42949&ap=1
    $15 shipped to the lower 48.

    PM me with interest please.
    thanks,
    Ken
    Last edited by ken werner; 03-28-2007 at 02:08 AM.

  2. #2
    Steve Clardy Guest
    pm coming. striking knife

  3. #3
    Join Date
    Dec 2006
    Location
    Charlotte, NC
    Posts
    1,487
    Dang nabbit Steve, now I got to make another one! Congrats!

  4. #4
    Join Date
    Oct 2006
    Location
    Central NY State
    Posts
    3,362
    Sale pending on all items. Knife is sold.
    Last edited by ken werner; 03-28-2007 at 05:29 PM.

  5. #5
    Join Date
    Dec 2006
    Location
    Floydada, Tx
    Posts
    1,941
    Ken, Did you sell everything yet? If not im intrested in the grizzly bits.

  6. #6
    Join Date
    Oct 2006
    Location
    Central NY State
    Posts
    3,362
    I'm sorry Al, all items are gone.
    Ken

Similar Threads

  1. A Few New Items
    By Bill Arnold in forum Computer-Aided Equipment Project Showcase
    Replies: 3
    Last Post: 01-01-2016, 01:26 AM
  2. Lumber Prices
    By Stuart Ablett in forum Flatwork Project Showcase
    Replies: 11
    Last Post: 10-01-2013, 01:38 AM
  3. Some really beautiful wood at a reasonable price
    By Rob Keeble in forum General Woodworking Q&A
    Replies: 2
    Last Post: 04-02-2012, 12:28 PM
  4. Prices
    By Frank Townend in forum Turning Tool Questions and Show & Tell
    Replies: 21
    Last Post: 10-27-2008, 08:37 AM
  5. Router bit prices
    By Dietrich Trenner in forum General Woodworking Q&A
    Replies: 6
    Last Post: 01-04-2008, 07:17 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •