Guy Bratt
Member
- Messages
- 64
- Location
- Richmond, MI near Port Huron
Hi
Now that the laminate is on my router top. I have an over hang of about an inch of laminate.
Is it ok to use a trim bit that will have to cut both sides of the laminate? To explain more I have 1 inch over hang can I use a 1/2 inch trim bit in one pass? In other words a 1/2 inch kerf. Or do I have to cut down the over hang in multiple passes?
Thanks
Guy
Now that the laminate is on my router top. I have an over hang of about an inch of laminate.
Is it ok to use a trim bit that will have to cut both sides of the laminate? To explain more I have 1 inch over hang can I use a 1/2 inch trim bit in one pass? In other words a 1/2 inch kerf. Or do I have to cut down the over hang in multiple passes?
Thanks
Guy