Results 1 to 5 of 5

Thread: Small pieces- sprayed

  1. #1
    Join Date
    Nov 2006
    Location
    Delton, Michigan
    Posts
    17,470

    Small pieces- sprayed

    Well i had some trouble in the past holding small pieces in place while trying to spray them, so when i needed to do some edge banding i came up with this plan to hold them still so i dint loose them while trying to spray them.. i just use a pin nailer and anchored them in the very out side edge and will trim off later after the finish is applied.. worked well so maybe others can get some benefit of this trick i have found useful
    Click image for larger version. 

Name:	small peices 001.jpg 
Views:	39 
Size:	47.2 KB 
ID:	75607Click image for larger version. 

Name:	small peices 002.jpg 
Views:	39 
Size:	62.9 KB 
ID:	75608
    If in Doubt, Build it Stout!
    One hand washes the other!
    Don't put off today till tomorrow!

  2. #2
    Join Date
    May 2007
    Location
    Kansas City, Missouri
    Posts
    13,437
    Nice solution.
    Darren

    To a small child, the perfect granddad is unafraid of big dogs and fierce storms but absolutely terrified of the word “boo.” – Robert Brault

  3. #3
    Join Date
    Apr 2007
    Location
    No, not all of SoCal is Los Angeles!
    Posts
    9,076
    Great tip Larry. I've also used double stick tape for this for things like pulls that won't take a pin.
    Any sufficiently advanced technology is indistinguishable from magic.
    - Arthur C. Clarke

  4. #4
    Join Date
    Nov 2006
    Location
    Delton, Michigan
    Posts
    17,470
    i thought about tape but the lacquer might have been more than the adhesive wanted but on a flatter piece i can see that working well glenn.
    If in Doubt, Build it Stout!
    One hand washes the other!
    Don't put off today till tomorrow!

  5. #5
    Join Date
    May 2007
    Location
    Thomasville, GA
    Posts
    5,992
    Lookin' good, pardner!!!
    Bill Arnold
    Citizen of Texas residing in Georgia.
    NRA Life Member and Member of Mensa
    My Weather Underground station

Similar Threads

  1. Cutting small &narrow pieces on table saw
    By Niki Avrahami in forum Jigs and Fixtures
    Replies: 2
    Last Post: 04-04-2008, 04:52 PM
  2. Cutting very small pieces on TS
    By Niki Avrahami in forum Jigs and Fixtures
    Replies: 1
    Last Post: 02-04-2008, 02:26 PM
  3. DP - Holding small pieces
    By Niki Avrahami in forum Jigs and Fixtures
    Replies: 5
    Last Post: 01-14-2008, 09:59 PM
  4. Replies: 8
    Last Post: 12-23-2007, 06:48 AM
  5. Getting small pieces of Corian
    By Aaron Beaver in forum General Woodworking Q&A
    Replies: 17
    Last Post: 07-08-2007, 04:30 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •