Drill press and Skill saw lathe....not for the faint of heart!

Oops, I didn't see this thread when I posted the same video a few minutes ago in the Off Topic area. :eek: Oh well, I'll leave it up for the entertainment\edumacation of the flatworkers who might miss seeing it here. ;)
 
I had stumbled on that video a few days ago, pretty wild. Note in one of his replies below that he is planning to set up to mechanically hold the skillsaw and hand crank it up and down and even in and out to adjust depth of cut. He is getting much closer to a working proposition then. Funniest thing to me is that all of this is sitting on a table saw. A table saw and a few mods actually makes an excellent doweling machine.

Hu
 
Top