John Terefenko
Member
- Messages
- 20
A while back I had shown a simple segmented pen with white acylic and red and black pickguard material. Within the posting and the thread I shown my jig for making this pen and on the jig I had another blank which was a black acrylic and aluminum inlay ready for turning. Some people recently asked if I ever finished the pen and I totally forgot to show it here. My bad as they say. So without further ado here is another simple segmented pen and in fact 2 of them.
In the first photo there is the 2 blanks I made. The one on the left was cut at 60 degree angle while the one on the right was cut at 45 degree angle with aluminum end rings added. The pens are Sierra Vistas. Thanks for looking and any comments or questions are always welcomed.
Edit-- I just went back on other posts and it turns out that I did show these after all. The thread was titled "From the Shop" Anyway this is for those that asked in the other thread to see them. Sorry for the double photos.
In the first photo there is the 2 blanks I made. The one on the left was cut at 60 degree angle while the one on the right was cut at 45 degree angle with aluminum end rings added. The pens are Sierra Vistas. Thanks for looking and any comments or questions are always welcomed.
Edit-- I just went back on other posts and it turns out that I did show these after all. The thread was titled "From the Shop" Anyway this is for those that asked in the other thread to see them. Sorry for the double photos.
Last edited: