Ken Fitzgerald
Member
- Messages
- 2,322
Here's my latest project I finished yesterday. Pardon the photos. The wife and I leave on a trip later this week and she has all 3 of her cameras packed. I shot these using my cell phone.
The carcass is scrap 3/4" red oak plywood trimmed out in white oak. Both were left over from previous projects. The top is doubled, screwed and glued 3/4" MDF for a final thickness of 1 1/2". The top and the working face of the fence was laminated with formica. Instead of using T-slots, I chose to install T-track. Inset is a Woodpecker's PRL-V2 and a PC 7518, 3 1/4hp router. Dust collection is done above and below the table top.
It's not my best work but it's been a learning experience and will serve me well for years to come!
The carcass is scrap 3/4" red oak plywood trimmed out in white oak. Both were left over from previous projects. The top is doubled, screwed and glued 3/4" MDF for a final thickness of 1 1/2". The top and the working face of the fence was laminated with formica. Instead of using T-slots, I chose to install T-track. Inset is a Woodpecker's PRL-V2 and a PC 7518, 3 1/4hp router. Dust collection is done above and below the table top.
It's not my best work but it's been a learning experience and will serve me well for years to come!
Last edited: